Giini Pyro Hazard

$39.99 USD

Shipping calculated at checkout.

In stock

We accept

Description

The Giini Pyro is a mechanical snowboard traction device that replaces foam stomp pads. Spring-loaded bumpers apply active pressure to your boot sidewall on contact, a mechanical lock that holds when friction-based pads are busy turning into ice rinks.

Hazard is high-vis industrial yellow and unapologetic about it. Built for the park crowd, the finish makes your landing zone instantly visible when you're setting up one-footed tricks, and it makes your board easy to spot when it's lying in the snow at the bottom of the feature. Loud color, louder grip.

Universal fit for any boot brand or size, goofy or regular. Peel-and-stick install in under a minute with industrial 3M VHB adhesive, rated to -40°. If it doesn't change your ride, we'll make it right.

Foam vs. Pyro. Not a fair fight.

Round Foam pad Giini Pyro

Wet grip Fails when iced Mechanical — unaffected

Snow buildup Packs in, then polishes Open chassis sheds it

Connection Hope plus friction Spring-loaded lock

One-footed control None Steer on edge

Lifespan 1–2 seasons Transfers to your next board

Same spring-loaded chassis under every colorway.

The numbers

Every measurement, no fine print

Width: 174 mm / 6.85 in
Depth: 119 mm / 4.69 in
Height: 35 mm / 1.38 in
Grip system: Active Tension — spring-loaded
Adhesive: 3M VHB industrial
Origin: Made in USA

-40° rated
3M VHB
Hardware, not a sticker

Asked constantly

Questions, answered

Does the Pyro interfere with riding when strapped in?

No. It sits between your bindings, an area that rarely contacts the snow during normal riding. The profile is low enough not to drag while carving and high enough to engage your boot when skating.

Will it damage my boots?

No. The bumpers that grip your boot are made of durable, non-abrasive rubber. They apply pressure to the sidewall of your sole, the toughest part of the boot, and leave no marks.

Can I move it to a new board?

Yes. The hardware transfers; the adhesive is single-use for maximum bond strength. To move it, warm the adhesive with a hair dryer, saw behind the device with dental floss, clean the residue with rubbing alcohol, and reinstall with a fresh strip of 3M VHB tape from any hardware store.

Why does it cost more than a foam pad?

Because it isn't one. A foam pad is a single piece of die-cut sticker foam. The Pyro is an assembly of molded composite parts, springs, and high-grade rubber, manufactured in the USA. Foam gets replaced every season or two. This gets transferred to your next board.

Why high-vis yellow?

Two reasons. When you're setting up a one-footer, you can spot your target zone instantly without hunting for it. And when your board is sitting in the snow between laps, Hazard makes it hard to lose. Park utility disguised as a style choice.